HOME PAGE | PREVIOUS PAGE


SMT 75
  • electro-pneumatic cutting machine for cutting, with drive or wheel measuring as option 
  • programmable acceleration and brake ramps
  • standrad interface RS 232 and stanard electrical exits for Tekuwa accessories such as de-reeler, stacker, re-reeler, fault lamp in case of loss of production
    Belt feed:
  • parallel driven belt feed supported by three rollers that protects the material while being transported
    with 10 speed steps and adjustable clamping pressure
    Application
  • Flat cable of a width of up to 70mm
  • uni- and heteropolar wires of a copper cross section of up to 70mm² (depending on the material)
  • Insulating tubes of an outer Ø of up to 36mm
    Operation
  • Microprocessor control unit with approx.250 program memories for memorizing
    production parameters
  • The following values can be memorized:
    number of pieces, batch quantity, length, length correction, cutting time, batch quantity waiting time, limitation of pulling force
  • Additional programming of marking time, begin of marking, end of marking, continuous marking for marking units and ink-jets
    Cutting Unit:
  • Pneumatic operation
  • Cutting blade, counter blade, blade guides made of tempered HSS-steel of high quality
    Options:
  • Wheel measuring
  • Additional guide block
    Range of models
    SMT 95 and SMT 115:
    The choice of the model depends on the material to be cut and the required maximum width of the material to be worked
    Width of feeder opening  SMT 95:     up to approx. 90mm
    Width of feeder opening  SMT 115:  up to approx. 100mm

    Technical Specifications :

    Dimensions ( L x H x D )

    490 x 360 x 480

    Weight

    approx. 45 kg

    Watt consumption

    400 Watt

    Power supply

    220 V / 50 Hz

    Air pressure

    5 - 10 bar

    Height of feeder opening

    20, 30, 40mm (depending on the customer’s requirement)

    Width of feeder opening

    75mm

    Cutting capacity

    up to 7000 cycles / an hour

    max. speed of belt feed

    0 - approx. 3m / sec.

    Cutting force

    Cutting cylinder with approx 2300, 3000, 3800 N


    • TOMKEN INDUSTRIES, INC.

    Phone: 203/847-8867 Fax: 203/847-5320
    HOME PAGE | PREVIOUS PAGE

    © 2005 TOMKEN INDUSTRIES INC.